enduser setup Module¶

Since	Origin / Contributor	Maintainer	Source
2015-09-02	Robert Foss	Robert Foss	enduser_setup.c

This module provides a simple way of configuring ESP8266 chips without using a serial interface or pre-programming WiFi credentials onto the chip.

After running enduser_setup.start() a portal like the above can be accessed through a wireless network called SetupGadget_XXXXXX. The portal is used to submit the credentials for the WiFi of the enduser. After an IP address has been successfully obtained this module will stop as if enduser_setup.stop() had been called.

Alternative HTML can be served by placing a file called enduser_setup.html in the filesystem. This file will be kept in RAM, so keep it as small as possible.

enduser_setup.manual()¶

Controls whether manual AP configuration is used.

By default the enduser_setup module automatically configures an open access point when starting, and stops it when the device has been successfully joined to a WiFi network. If manual mode has been enabled, neither of this is done. The device must be manually configured for wifi.SOFTAP mode prior to calling enduser_setup.start(). Additionally, the portal is not stopped after the device has successfully joined to a WiFi network.

Syntax¶

enduser_setup.manual([on_off])

Parameters¶

• on_off a boolean value indicating whether to use manual mode; if not given, the function only returns the current setting.

Returns¶

The current setting, true if manual mode is enabled, false if it is not.

Example¶

wifi.setmode(wifi.STATIONAP)
wifi.ap.config({ssid="MyPersonalSSID", auth=wifi.OPEN})
enduser_setup.manual(true)
enduser_setup.start(
  function()
    print("Connected to wifi as:" .. wifi.sta.getip())
  end,
  function(err, str)
    print("enduser_setup: Err #" .. err .. ": " .. str)
  end
);

enduser_setup.start()¶

Starts the captive portal.

Syntax¶

enduser_setup.start([onConnected()], [onError(err_num, string)], [onDebug(string)])

Parameters¶

• onConnected() callback will be fired when an IP-address has been obtained, just before the enduser_setup module will terminate itself
• onError() callback will be fired if an error is encountered. err_num is a number describing the error, and string contains a description of the error.
• onDebug() callback is disabled by default. It is intended to be used to find internal issues in the module. string contains a description of what is going on.

Returns¶

nil

Example¶

enduser_setup.start(
  function()
    print("Connected to wifi as:" .. wifi.sta.getip())
  end,
  function(err, str)
    print("enduser_setup: Err #" .. err .. ": " .. str)
  end
);

enduser_setup.stop()¶

Stops the captive portal.

Syntax¶

enduser_setup.stop()

Parameters¶

none

Returns¶

nil